Race-Keeper System Release 2.5.7.3 (09-10)

Race-Keeper System Software (4.2 MB)

New Features
Revise hardware register settings – colour, colour saturation and clarity – for enhanced video quality
Enable expanded OBD-II data acquisition
Enable Bosch CAN ECU data acquisition
Enable Pectel CAN ECU data acquisition
Change default WiFi essid to Race-Keeper
Expand WiFi setup options

Revisions
Add more robust WiFi handling
Add filter to shut down system when input voltage is > 16V
Enforce minimum per-encoder bit rate
Expand iDash functionality
- Add get/set configuration
- Add start/stop outings
- Add calibrate accelerometer

Race-Keeper System Release 2.3.2 (04-10)

New Features
Enable Race-Keeper iDash
Support for WiFi
Streaming data
Two new PIP options
Support for license management
Support for digital sensors
Addition of RFID reader interface
Support for RPM ripple and calibration

Revisions
Start/stop on speed from any data source
Minimum storage space requirements for SD card and/or USB stick
Capability to recognize older generations of USB sticks
Eliminates intermittent dark screen on power up

Race-Keeper System Release 2.1.2.0 (11-09)

New Features
Outing data format updated to more compact single file form
Outing data can be secured with password
Status LED blinks red if GPS signal is not locked
Auto power-on configuration option
Initial native CAN support
Support new GPS firmware
Broadcast GPS device messages on CAN bus

Revisions
All times are now UTC
Prefer USB storage over SD storage
Memory LEDs now turn on at 25, 50, 75, 90, and 100% full
Bitrate refers to total video bitrate (not individual stream bitrate)
Tweaked VMUX settings to reduce interference
Start on RPM and start on MPH triggers from CAN data
Better support for all GPS device firmware
Start on ID works when key already present at boot
Outings no longer limited to 4GB video file size
Start on MPH trigger resets while a previous capture is stopping (instead of when completely stopped)